|
|
Specifications:
-2 boring units each with 25 spindles, pitch 32
-Distance between boring units min. 145mm max. 608mm
-Position adjustment of stopping fence 0-120mm( setback set at 37mm)
-Max.workpiece thickness 100mm
-2 motors 2.5hp, 220V, 60 cycles, 3ph
-Working Height of machine 850mm
-Compressed Air requirement 85psi
- Space requirement without full fences 63x48 inches
|
|
|
|
|
|
|
|
|
|
|
|
|
Proline Advantages
- 2 boring units each with 25 spindles, pitch 32mm.
- Each boring unit has 3 individual clamping cylinders.
- The strong double-guided boring unit guarantees stability especially at the ends of the drilling beam.
- The first boring unit is fixed at the front of the machine for easy handling of small workpieces.
- The second, a rear boring unit is easily moveable by precision guides indexed by a digital counter.
- To minimize setup time, the rear fence, including extension ruler stops, are moved together with the rear drill head and hold-down cylinder.
- Precise line drilling by use of tilt-stops and setting gauge (no indexing pin).
- The extension ruler (2200mm) can be turned from left to right side for perfect mirror image.
- Chip-free through-boring with hydraulic oil-break cylinder.
- Ideal two-stage drill bit system with high speed chucks.
- Large table for workpiece support.
Advantages- drilling from below
- Safer because drill bits are covered by work piece.
- Drilled chips automatically fall out of holes resulting in:
a) clean holes for inserting dowels, hinges and hardware
b) cleaner work table, stops and finished work piece
- no separate cleaning necessary.
c) immediately stackable panels
d) faster drilling cycle
- Constant boring depth.
- Easy through-drilling with the use of hydraulic oil brake and V-point bits. No accidental drilling into the table surface.
- Work piece protected because outer surface of side panels face upwards, not down against the table surface.
- Longer tool life.
|
|
|