Line Boring for Closets and Cabinets

Specifications:

2 drilling beams each with 21 spindles, pitch 32mm.
- Position adjustment of the boring units 0-650mm. Both boring units move.
- Min distance between drill heads 190mm
-Spindle speed 3400 rpm
-Drill shank diameter 10mm (standard)
-2 motors 1.5 KW 220V, 60 cycles, 3ph
-Working height 850mm
-Air requirement 85psi
-Weight 250 KG

Fotprint without stopping ruler 850x1100mm

 

 

Strong, double-support for drill heads guarantees stability even when drilling at the ends of the drill heads.

Easy horizontal movement of the drilling beams by ball-bearing guides.

Precise inline drilling by use of tilt-stops and setting gauge (no indexing pin). Short set-up time. Extension ruler can be turned from left to right side. Stops rotate 360 degrees.

Chip-free in-line through boring with hydraulic oil brake.

Drilling from below with all the well known advantages.

The machine sets up to drill for cam fittings, either the out rigger type (2 holes) or single cams (1 hole) and because the machine drills from the bottom you can also accurately drill for the flush set cams from Hafele.

  • Advantages- drilling from below
  • Safer because drill bits are covered by work piece.
  • Drilled chips automatically fall out of holes resulting in:
    a) clean holes for inserting dowels, hinges and hardware
    b) cleaner work table and finished work piece- no blowing out holes, immediately stackable panels.
    c) faster drilling cycle
  • Constant boring depth.
  • Easy through-drilling with the use of hydraulic oil brake and V-point bits. No accidental drilling into the table surface.
  • Work piece protected because outer surface of side panels face upwards, not down against the table surface.
  • Longer tooling life.