The Gannomat Express S2 Hinge, hinge plate and hardware insertion machine

front of express hinge and hardware insertion machine

The Express S2 is a fully automatic drilling and inserting machine for hinges hinge plates and other insertable hardware.

Features:

-Rigid steel base construction.
-Integrated drilling and inserting unit.
-Automatic feeding and inserting of hinges
by magazine and inserting die.
-Standard 4-spindle drill head with high-speed spindle chucks.
-Right drill head(s) travels on linear guideways and is locked with pneumatic brake controlled by push button for fast alignment to different length parts.Cycle time approximately 5 seconds for drilling AND inserting.
-Program selector switch for drilling only, or drilling and inserting modes.
-Maintenance-free inserting die guides.
-Drilling from below with the well-known
advantages.
-Available with 1, 2, 3 or more drilling and
inserting stations (i.e. S1, S2, S3, etc.)
-A tilt forward magazine design facilitates the easy loading of hardware during the machine cycle.
-Fully automatic maintenance-free electronic control, operated with foot pedal.
(Self-diagnostic program).
-Exhaust device collects dust and chips at the drill head for top efficiency.
-Dual flip stop rails at each head allow for more hinge setbacks.

front view of the Gannomat Express S2 hardware insertion machine

The die and magazine are removable so that the machine can be setup to insert different hardware types.

a sampling of hinge types the express S2 will automatically insert

The Express S2H is designed to insert hinges, hinge plates, hinges with plates attached, drawer adjusters and RTA fittings.

Cycle time for the Express is 4.5 seconds to drill for and insert two hinges.

Each head has a magnetic detector safety to prevent previously inserted parts from being inserted again thus ruining both the part and the machines tooling.

program selection switches The Express has a three hinge insertion program which cycles the heads on and off first inserting two hinges and than cycling one head off to insert the third hinge.

The left head on the Express S2 H is stationary and the right head opens and closes for different workpiece widths. The brake for the right head is released by pushing the green button on the handle on the right head. It will than move along linear bearings for an effortless setup.