Fully automatic drilling and inserting machine for all types and brands of hinges, hinge plates, furniture and cabinet fittings.

• Rigid steel base construction.
  Integrated drilling and inserting unit.
• Standard 4-spindle drill head with high-speed spindle chucks.
  
• Automatic feeding and inserting of hinges by magazine and inserting die.
  
• Cycle time approximately 5 seconds for drilling AND inserting.
  
• Lighted program selector buttons for drilling only, or drilling and inserting modes.
  
• Maintenance-free inserting die guides.
  
• Drilling from below with the well-known advantages.
  
• Exhaust device with 80mm Ø connection.
  
• Magazine can also be loaded during the operation cycle from the front because the magazine is tilted forward.
  
• Quick-change magazine and inserting die.
  
• Fully automatic maintenance-free TELEMECANIQUE electronic control, (Self-diagnostic program).
  

  Complete in standard equipment, including:                           
  1 Drilling and inserting station with magazine and inserting die according to hinge/hardware model
  1 Drill head (drilling pattern, pitch as required)
  1 Pneumatic brake for drilling speed control
  Fully automatic electronic control; self-diagnostic PLC
  Operating switches at the station: 
  ON/OFF, Emergency stop,
  Start button
  Program selection for drilling only or drilling and inserting.
  1 Exhaust port  Æ 100mm.  (adequate dust collection is mandatory for this machine)   
  Safety control with metal detector
  1 Basic stopping ruler 300 mm with 2 tilt-stops (0800-0620)
  1 Extension ruler 1000mm with 2 latch stops (0800-0650)Motor:  1.5kw; 220v; 3 phase; 60Hz

Inserts all types of cams including plastic and metal.*

Dual level stopping setup allows for patterns that are very close in size without ahving to adjust stops.

Safety metal detector protects against re-drilling already inserted parts. A limit switch protects the detector by preventing the machine from cycling when no material is present.

 

 

Revised Jul 1, 2010